• Made from solid brass, so the finish carries right through the screw and will not flake or chip like plating.
• Countersunk head sits flush with the timber surface for a clean, traditional look.
• Slotted drive suits a flat-head screwdriver and gives an authentic period finish.
• Good natural corrosion resistance for coastal, marine and damp interior work.
• Colour matches brass and bronze ironmongery, so fixings blend in rather than stand out.
• Single full thread for a firm grip in softwood and hardwood alike.
• Available across common gauges and lengths for restoration and joinery jobs.

These screws suit any job where the fixing needs to match traditional brass hardware or hold up in a corrosive spot. Typical uses include:

• Period property restoration and heritage joinery.
• Fitting brass or bronze hinges, handles, latches and escutcheons.
• Marine and coastal joinery, including boat fit-out.
• Decorative hardwood work where the screw head is on show.
• Door and window ironmongery that calls for a matching finish.

• Brand: TIMCO
• Material: Solid brass
• Head type: Round (dome)
• Drive: Slotted
• Thread: Single, full thread
• Finish: Polished brass
• Uses: Fixing brass fittings, brackets and plates to timber, period restoration, marine work
• Sizes: Roughly #4 to #10 gauge, 12mm to 50mm lengths
• Pilot hole: Recommended in hardwood (brass is soft)
• Magnetic: No
• Pack: Box or bag

Are brass wood screws as strong as steel screws?

No, brass is softer than steel, so these screws have lower shear and pull-out strength. They are chosen for their finish and corrosion resistance, not raw strength. For structural loads use a steel screw, and keep brass for hardware, trim and decorative fixing.

Do I need to drill pilot holes for brass screws?

Yes, a pilot hole is strongly advised, especially in hardwood. Because brass is soft, driving it dry into dense timber can twist the head or round out the slot. Drill a pilot the width of the shank, and a clearance hole in the top piece, then drive slowly.

Are brass wood screws magnetic?

No, solid brass is not magnetic, so a magnetic screwdriver will not hold these screws in place. Seat the screw in the slot by hand, or start it in the pilot hole before driving. A well-fitting flat-head bit helps keep control.

Will brass screws rust outdoors?

Brass does not rust the way steel does, since it contains no iron. It resists corrosion well in coastal and marine conditions, which is why it is used on boats and exterior brass fittings. Over time the surface will dull and patinate, but it keeps its integrity.

What screwdriver do I use for slotted brass screws?

Use a flat-head (slotted) screwdriver that fills the width and depth of the slot. A bit that is too narrow will chew the slot and spoil the look. Hand driving gives the most control and reduces the risk of damaging a soft brass head.